Re: [mad-dev] Arm cross compile

Hi

Thanks for your advice but I checked and mad.h and id3tag.h are both already in /usr/local/include and libmad* is in /usr/local/lib.

I've tried

# RANLIB=arm-linux-ranlib CC=arm-linux-gcc ./configure --host=arm-linux CFLAGS="-I/usr/local/include -L/usr/local/lib"

and although it gets past mad.h:

checking mad.h usability... yes checking mad.h presence... no configure: WARNING: mad.h: accepted by the compiler, rejected by the preprocessor! configure: WARNING: mad.h: proceeding with the compiler's result checking for mad.h... yes

its stil complains about libmad:

checking for mad_decoder_run in -lmad... no configure: error: libmad was not found

Any Ideas

TIA

Andy Douglas

On Sun, 13 Mar 2005 07:16:14 +0100, pmisteli pmisteli@terpalum.umd.edu wrote:

On 2005 Mar 12, at 22:47, Andrew Douglas wrote:

...

Hi

I wonder if anyone can help. I'm trying to cross compile madplay-0.15.2b for an arm9 processor running a 2.4.18 kernel. I'm building the source on a redhat9 host. I do the following:

$ ./configure && make && make install

for libmad and libid3tag. Then I try configuring madplay with the following command:

$ RANLIB=arm-linux-ranlib CC=arm-linux-gcc ./configure --host=arm-linux

and get the following error:

checking mad.h usability... no checking mad.h presence... no checking for mad.h... no configure: error: mad.h was not found *** You must first install libmad before you can build this package.

I include the libmad dir with CFLAG and then it complains about libid3. I include this then it complains:

configure: error: libmad was not found

This doesn't seem right. Is there something I've done wrong.

Any hints would be appreciated.

TIA

Andy Douglas

Hello,

Here is a hint :

check the libmad installation :

    find /usr/local -name mad.h

If mad.h is not there, you might not have permissions for /usr/local, you may need to do

    sudo make install

for libmad (and libid3).

Hope this helps, pmisteli