Hi all,
I run into trouble when I try to configure the Madplay under my cross-platform development. After I untar the package I do follwing step to setup the Madplay entironment.
export CC=arm-lynx-linux-bluecat-gcc export RANLIB=arm-lynx-linux-bluecat-ranlib export LD=arm-lynx-linux-bluecat-ld export NM=arm-lynx-linux-bluecat-nm
./configure --build=i386-linux --host=arm-linux --target =arm-linux --enable-fbm=arm -enable-sso --prefix=/bluecat/cdt --exec-prefix=/blu ecat/cdt
then the config procedure and make procedure pass smoothly but when make install I trap into the trouble I reported yesterday:
make[1]: Entering directory `/bluecat/mad/po' if test -r "../././././mkinstalldirs"; then \ ../././././mkinstalldirs /usr/local/share; \ else \ /bin/sh ../././mkinstalldirs /usr/local/share; \ fi ../././././../././././mkinstalldirs: Can't open ../././././../././././mkinstalldirs
I modified the makefile maually today by delete the following line in makefile
SUBDIRS = intl po $(libz) libid3tag libmad $(winamp) the make install pass and all thing seem OK.
But when I try to run the madplay on my target board(Ep7312) the follwing message display
bash# ./madplay -o raw:- ./funky.mp3 >/dev/null MPEG Audio Decoder 0.14.2 (beta) - Copyright (C) 2000-2001 Robert Leslie 2373 frames decoded (0:01:01.9), -2.2 dB peak amplitude, 0 clipped samples bash#
But there have not any noise during this procedure when the BlueCat demo run OK.
There some question confuse me, 1) What's the function of directory under mad name po,msvc++ and intl ? 2) Is there anything wrong with my ./configure procedure?
Pls give me advice.
Thank for you help and Merry Xmas.
With regards, healy yang E-mail:healy_yang@china-SSI.com ____________________________________________________________ Sichuan Starlight Internet-appliances Ltd. 升威信息电器公司 Tel: (86-28) 5185891 Fax: (86-28) 5136351